Editing Step 1 —
Connecting via Ethernet

Notice: You are now editing a prerequisite to the guide you were just viewing. Any changes you make will affect all 2 guides that include this step.

Step Type:

Drag to rearrange

Ensure that an Ethernet cable has been plugged into the rear of the electronics box

If your unit is not on, please flip the top power switch on the back of the electronics box to the on position.

Once the unit powers on, go to the touchscreen and select the SETTINGS tab at the bottom of the screen. check the IP address at the bottom of the SETTINGS tab.

If the IP address shows 0.0.0.0, select the Consol Tab across the bottom of the screen and enter in "M552 S1". The consol will then spit out your IP address for the Ethernet

Once you have your IP address you will be using it in the next few steps.

Your contributions are licensed under the open source Creative Commons license.