How to unbox your unit

Move your box to a floor ensuring the box is upright.

Cut the tap at the top of the box

Open the box and remove the top foam

(We recommend having two people for this next step)

With one person on opposite sides of the box. Each person should grab the top aluminum with one hand and the top of the box with the other.

Pull up evenly on both sides of the unit while pushing down the box.

Once the unit is lifted free from the box, center foam, and base foam; place the unit on a table.

Now you should remove the zip ties from the XY belt system.

Gently push your gantry towards the Y max (Rear of the unit)

Slide the bottom white box from under the bed and set it to the side.

Pull the interior foam out of the unit, it is okay if the front of the bed drops slightly but do not move it all the way down.

Move to the White Box that was removed from below the bed.

Inside the White Box, you will find the following:

1kg spool of filament for first prints.

Power Cable and HDMI Cable (for diagnostics)

USB stick

5in Touch Screen and Spool Holder (Two M5x10 bolts to mount the spool holder and two M5x10 bolts to mount the display)

Tools: T-Handle Hex 2mm, 2.5mm, 3mm

Filament sensor with bowden tube (one M5x10mm bolt for mounting filament sensor)

If you intend to use a wall-mounted spool holder or RepBox, you do not need the spool holder

On the right side of the printer, locate the second and third bolts across the top edge from the front that holds the acrylic to the aluminum.

Remove the second and third bolt, these bolts will no longer be used.

Mount your spool holder using the two M5x10 bolts included.

On the right side of the printer, locate the fourth bolt across the top edge from the front that holds the acrylic to the aluminum.

Remove the fourth bolt, this bolt will no longer be used.

Mount the Filament Sensor mounting plate with the included M5x10mm bolt

Mount the Filament Sensor to the mounting plate with the included M3 Bolts ensuring the bowden tube is coming out of the top of the sensor.

Insert the other side of the bowden tube into the BondTech Extruder.

On the top of the unit, your display will mount across the front extrusion.

The right M5x10 bolt will go into the tapped end of the aluminum

The left M5x10 bolt will go into the slidable nut.

Once the screen is mounted, plug in the screen. The plug is keyed so you can only plug it in one way.