-
-
The CXC is developed by Ember Prototypes.
-
All of their documentation and software can be found here:
-
-
-
-
-
Before running the software and using the CXC its always good to make sure the offsets are already set at U0 Y0
-
Navigate to System>Config.g and scroll down to Tools
-
Find that the second tool will have a line that reads
-
G10 P1 U0 Y0 Z0.0
-
Ensure it is not commented out by ensure the ; is not at the beginning
-
The line below it with the previous offset should be commented out, see the photo for reference.
-
Once that is saved you can now start the process and follow the directions in the CXC software.
-
At the end the CXC software will give you the new offset
-
-
-
Navigate to System>Config and down to the Tool section again.
-
Comment out the following line
-
G10 P1 U0 Y0 Z0.0
-
Insert your new offset in the line below (remember that the X value given by the CXC Software will go next to the U)
-
Be sure you uncomment out the new offset value and save
-
